TritiumGlo
New member
So, I got my 2615 back today from the dealer. It was in for service. The internal rod that drives the 3 point snapped like a twig. So today I went to get the allegedly repaired machine. 1st it was dumping fluid on the ground out of the speed control. They forgot to put a bolt in. 2nd the brake was disconnected. Glad I wasnt moving when I discovered that. Then finally, the 3 point controls. I always set the draft side and let it be. Then I used the inside lever to control height. I remember 3 being a good place to brush hog. Now the draft or right lever raises and lowers the 3 point. The inside lever has little to no effect on the hitch? When fully raised it sounds like there is pressure in system not being relieved. Its almost like they reversed the lever controls if thats even possible. Never did that before. WTH did they do to this tractor?