mcentyre
New member
This is probably a dumb question.
My Long 2360 is having lift issues (won't lift with any load, but will lift with no load). I looked at the cylinder o-rings and they looked fine but since I was there, I ordered all the rings to eliminate them as a problem. One of the rings I ordered was the back up ring TX12279. I can't figure out where it's suppose to go. I didn't see anything like it during disassembly. Either it was missing or I'm not understanding where it is. I have the parts diagram and it's not helping much.
Anyone give me a push in the right direction?
My Long 2360 is having lift issues (won't lift with any load, but will lift with no load). I looked at the cylinder o-rings and they looked fine but since I was there, I ordered all the rings to eliminate them as a problem. One of the rings I ordered was the back up ring TX12279. I can't figure out where it's suppose to go. I didn't see anything like it during disassembly. Either it was missing or I'm not understanding where it is. I have the parts diagram and it's not helping much.
Anyone give me a push in the right direction?
