kubota L3010

[jcottons]

I dont know if this is the right area but here it goes, i have a KUbota L3010 and am wanting read hydraulics on it, I have seen alot of people run them off of the front end loader but being me i am not sure wich hoses to run them to the back? Does anyone know of a valve body kit that i can bolt on and not have to do this? Or does anyone know what hoses to run them off of the loader to the back?

Thanks in advance!:thumbsup:

 

[J_J]

You can use the curl circuits for hyd at the back.

If your FEL valve has PB outlet, you can run a remote valve at the rear by adding a PB adapter to the FEL valve, or if your tractor has a hyd block, use that for the hose to the remote valve.

From the hyd block, a hose will feed the IN port of the remote valve. and the PB out of the remote valve will go to the 3pt.

 

[CarterandCarter]

Thanks, I just had a customer ask the same question

 

[jcottons]

thanks J J,. do you happen to know of an aftermarket kit that is available for a valve?

Years ago i put a Valve on a ford 3000 so i could have hydraulic remotes in the back and was hoping that Kubota may have one. Cant seem to find one in my area

If not then i will go the route you described

 

[J_J]

If you are going the remote route, then if you want to piece a kit together, there are places like below that has just about everything you need.

First thing is to find a place to mount the valve, that is in a sturdy and convenient position.

Here is a two spool with PB.

Surplus Center - 2 SPOOL 14 GPM PRINCE WVS21BB5C1 DA VALVE

3 spool with PB.

Surplus Center - 3 SPOOL 14 GPM PRINCE WVS31BBB5C1 DA VALVE

Does your FEL valve have PB port, or do you have the hyd block on the side of the tractor frame?

 

[ouhunter]

I have a Kubota L3010 GST and was wondering if anyone that has installed rear hydraulics has any pictures or diagrams on how they installed theirs. I would like to see some from the FEL but any would be great. I've already read a lot of great advice but it would really sink in and help being able to also see pictures. I've mainly had JD's over the yrs, 4010's, 4020's, 4430 and 2940 so this is the first tractor I've owned without rear hydraulics. I need it to mainly work a Bale Unroller Clamps, raise & lower a 10 Wheel Hay Rake, raise & lower a Disc and raise & lower a 7' Finish Mower, maybe a few more but not anything heavy and just wanting two hook-ups. Thanks