Hey guys,
I'm researching a way to adapt the 60, 70, & 70A loaders to fit my JDQA Pallet Forks design. I was looking up the 420 loader for someone's question and discovered that there may already be something from John Deere that would work (Items 7 & 10 in the attached image). Does anyone happen to know if that JDQA "Holder" would fit the pin configurations of the 60, 70, & 70A loaders?
I've been planning to design this but if it is already available, I could just advise folks to buy these and make their loaders JDQA compatible.
Basically, it is just a matter of the spacing between the pins and the pin diameters, I think.
I'm researching a way to adapt the 60, 70, & 70A loaders to fit my JDQA Pallet Forks design. I was looking up the 420 loader for someone's question and discovered that there may already be something from John Deere that would work (Items 7 & 10 in the attached image). Does anyone happen to know if that JDQA "Holder" would fit the pin configurations of the 60, 70, & 70A loaders?
I've been planning to design this but if it is already available, I could just advise folks to buy these and make their loaders JDQA compatible.
Basically, it is just a matter of the spacing between the pins and the pin diameters, I think.
Attachments
Last edited: