JD X300 cranks but doesn't start

   / JD X300 cranks but doesn't start #1  

willemcraven

New member
Joined
Apr 14, 2014
Messages
2
Location
Midlothian
Tractor
John Deere X300
I've put in clean fuel, replaced plugs, it starts and runs for a few seconds when I spray starter fluid in the carb. I am thinking this might be some sort of shear pin/bolt that has gone, my blades take a lot of abuse.

If anyone knows if this is the case and can point me in the right direction on replacing one, much appreciated.

The grass is growing as I type!

Willem
 
   / JD X300 cranks but doesn't start #2  
carb stopped up or filter not a bolt or shear pin
 
   / JD X300 cranks but doesn't start
  • Thread Starter
#3  
carb stopped up or filter not a bolt or shear pin

Pulled carb, not too dirty but cleaned it up.

Checked fuel lines, cleaned as well as I could.

Finally cranked and running!! Just in time for rain today.

Thanks,
Bill
 

Tractor & Equipment Auctions

2022 FREIGHTLINER CASCADIA SLEEPER (A51222)
2022 FREIGHTLINER...
2020 JLG 1732 16,755lb 4x4 High-Capacity Rough Terrain Telehandler (A49461)
2020 JLG 1732...
2021 Case IH Magnum 240AFS CVX Connect MFWD Tractor (A50657)
2021 Case IH...
2014 MACK CHU TANDEM AXLE DAY CAB (A51219)
2014 MACK CHU...
2003 - 1890/1910 Air Seeder and Air Cart (A51039)
2003 - 1890/1910...
GARDNER DENVER 480 VOLT AIR COMPRESSOR (A50854)
GARDNER DENVER 480...
 
Top