JD 300B Backhoe Pin removal

[klc336]

Hey guys I was looking for a little guidance on this. I'm currently removing the bucket cylinder hoses off the back hoe. Which are a pain to get to. And I noticed that if I could just knock out the cylinder pin in the top of the cylinder I could pull it out a bit and have easy access to the lines. All the lines for this machine are run through the boom. All I see are a bolt and a spacer on either side of the pin and once removed it looks like the ends of the bushings and the pin. I was wondering if there's a trick to getting the bushings and pins out without too much damage to them. Thanks.