It's Finally Here!!!!!

[Mace]

It\'s Finally Here!!!!!

My 1500D FINALLY showed up. Everything works great. The hour meter shows 240 hours, but according to the dealer it is 1240. I had to disconnect the little bars inside the lift arms to get them to spread far enough apart to mount the PHD......Dug a three foot post hole in less than 5 minutes. Was I stoked!!!!

 

[Mace]

It\'s Finally Here!!!!!

My 1500D FINALLY showed up. Everything works great. The hour meter shows 240 hours, but according to the dealer it is 1240. I had to disconnect the little bars inside the lift arms to get them to spread far enough apart to mount the PHD......Dug a three foot post hole in less than 5 minutes. Was I stoked!!!!

 

[California]

Re: It\'s Finally Here!!!!!

Congratulations! You're going to love that thing.

Welcome to the family of Yanmar owners!

 

[California]

Re: It\'s Finally Here!!!!!

Congratulations! You're going to love that thing.

Welcome to the family of Yanmar owners!

 

[LMTC]

Re: It\'s Finally Here!!!!!

</font><font color="blue" class="small">( The hour meter shows 240 hours )</font>
Good for you....you apparently did not get a recon.

 

[LMTC]

Re: It\'s Finally Here!!!!!

</font><font color="blue" class="small">( The hour meter shows 240 hours )</font>
Good for you....you apparently did not get a recon.

 

[BruceR]

Re: It\'s Finally Here!!!!!

Mace,
Glad the wait is over. Can you post some photos ?

Bruce

 

[BruceR]

Re: It\'s Finally Here!!!!!

Mace,
Glad the wait is over. Can you post some photos ?

Bruce

 

[michigandon]

Re: It\'s Finally Here!!!!!

</font><font color="blue" class="small">( I had to disconnect the little bars inside the lift arms to get them to spread far enough apart to mount the PHD......)</font>

I see I'm not the only one with this problem. IMO the three point conversion kits for these grey market machines are kinda cheesy. /forums/images/graemlins/frown.gif They do get the job done however, if one excercises a little patience when hooking and unhooking implements.

 

[michigandon]

Re: It\'s Finally Here!!!!!

</font><font color="blue" class="small">( I had to disconnect the little bars inside the lift arms to get them to spread far enough apart to mount the PHD......)</font>

I see I'm not the only one with this problem. IMO the three point conversion kits for these grey market machines are kinda cheesy. /forums/images/graemlins/frown.gif They do get the job done however, if one excercises a little patience when hooking and unhooking implements.