Iron Horse 284

[starrslight]

I am trying to find the part that lifts the bucket to an Iron horse
284.

Any help would be greatly appreciated.
(trying to fix this for my Dad)

 

[Harry in Ky]

Doesn't look like there's much there to fix. I'd be looking for a replacement loader valve. Lots of them available but it will require a little effort on your part to get the mounting and plumbing done correctly.

 

[starrslight]

Doesn't look like there's much there to fix. I'd be looking for a replacement loader valve. Lots of them available but it will require a little effort on your part to get the mounting and plumbing done correctly.

Would you know where I may get this part?

 

[fidowanttobe]

Affordable Tractor Sales Co. LLC
6972 Highway 36 North
Bellville, TX 77418
Phone: (979) 865-4002
Fax: (979) 865-5183
Website: Home of compact Jinma, Foton, and Koyker Tractors and Parts, Wood Chippers, Backhoes - Affordable Tractor Sales Company

 

[Harry in Ky]

Affordable Tractor Sales Co. LLC
6972 Highway 36 North
Bellville, TX 77418
Phone: (979) 865-4002
Fax: (979) 865-5183
Website: Home of compact Jinma, Foton, and Koyker Tractors and Parts, Wood Chippers, Backhoes - Affordable Tractor Sales Company

I'm curious to see how that works out.

 

[fidowanttobe]

This gentleman built me a kit for my 2007 Jinma, very very happy with it. I would start there. I believe text is a faster response, phone number on this site.
www.ranchhandsupply.com

 

[starrslight]

This gentleman built me a kit for my 2007 Jinma, very very happy with it. I would start there. I believe text is a faster response, phone number on this site.
www.ranchhandsupply.com

Could you post a picture of your tractor with this kit on it? Also was it hard to install?

 

[fidowanttobe]

I'll try to photo this weekend but doubt it will show you much as it will be different than yours.
My 2007 Jinma with the ZL-20 loader had the stock single handle valve that weeped and oozed since new and I finally called Ronald about 4 years ago. He asked me a bunch of questions until he knew what I had. Sent me a retro kit that had the right connections and hoses and brackets etc. Bolted right on. As I said earlier, very happy with it. Only thing that ticked me off was that I put up with the old one for so long.
Try to find placards or model/serial numbers before you call.

 

[starrslight]

I'm curious to see how that works out.

Didn't work out; decided to go with Ronald at www.ranchhandsupply.com

 

[Harry in Ky]

So was that successful?

 

[starrslight]

Not sure yet. Once I get the part and get it on, I'll post how successful it was. At least he does respond. Hoping it's a success

 

[fidowanttobe]

Good luck.