ignition switch jimna 354 4wd tractor

[garyvfr1]

Can someone please help !!!!
I broke the original ignition switch (prefixed with JK40..) however the dealer said they no longer sell this model and has been replaced with jk290a
when I received it there was no wiring diagram ! Could someone tell me what wires go to which connectors even better could someone send me a picture detailing it
as you may of gathered I am a new member and no good with electrical wiring
Finally how do I know when someone has responded to my post
Thanking you all in anticipation
Regards Gary
:confused2:

 

[PILOON]

Finally how do I know when someone has responded to my post.

Like this! LOL, however it would be hard 4 me to help.

Using tractor wire diagrams and the new switch diagram it should be possible to accomplish the transplant.
Good luck and welcome to TBN.

 

[Kubota 2350]

Finally how do I know when someone has responded to my post.

Like this! LOL, however it would be hard 4 me to help.

Using tractor wire diagrams and the new switch diagram it should be possible to accomplish the transplant.
Good luck and welcome to TBN.

You can subscribe to the thread, or check back now and then.

 

[garyvfr1]

thanks for your response however
" Using tractor wire diagrams and the new switch diagram" it should be possible to accomplish the transplant.
I have neither
the diagrams i found online are an utter waste of space would have more success in running a marathon NOT (minds willing but the body aint)ha
would appreciate further assistance if anyone out there has any advice
AND NO I WONT SET LIGHT TO IT AS ITS NOT INSURED.........:thumbsup: