How long has Chucke2009 been back?

[stuckmotor]

I just found this

Stretch had put some of his old videos back up a while back and they disappeared. Maybe he's been punished enough that they'll let his "WELDING" videos stay up.

 

[Sawyer Rob]

Too long, he's gotten REALLY weird! I can no longer support him.

SR

 

[stuckmotor]

Too long, he's gotten REALLY weird! I can no longer support him.

SR

I tuned out when he got political.. The vids I liked best were made before he left Ohio. They reteach some basics I forget from time to time.

 

[ZetorSteve]

Too long, he's gotten REALLY weird! I can no longer support him.

SR

Yes, he has. Watched his update rant video and he is pushing religion real hard now. Good for him I suppose but if I want to be preached at I'll go to church. Really enjoyed his welding videos and learned a lot from him in that respect. Nothing stays the same or last forever I suppose.

 

[5030]

Compared to most of the garbage vids on Pew Tube, his ain't bad.

 

[ZetorSteve]

Compared to most of the garbage vids on Pew Tube, his ain't bad.

This is true.

 

[sd455dan]

I liked his early vids, but for now will stick with This old Tony, ZILA and Welding Tips and Tricks with Jody

 

[etpm]

I liked his early stuff. Then he started talking about how he was going to church. Then he made some statements that were outright lies and had nothing to do with welding or fabbing or farming. So I stopped watching him and put his videos on the do not recommend list. I won't start watching him again either. There are too many other posters who have lots of good info to share and don't feel the need to propagandize.
Eric

 

[stuckmotor]

Mechanic Steve has started a new channel and isn't posting to his old channel. He explains the reason be!ow. The new channel is called Stephen Cox's Other Channel.

 

[California]

I just found this [welding vid]
Stretch had put some of his old videos back up a while back and they disappeared. Maybe he's been punished enough that they'll let his "WELDING" videos stay up.

Maybe a tweaker? That vid covers a very simple subject but Chucke describes it with overwhelming intensity! He takes far too long for the simplicity of his project.

He got banned off YT? For what specifically? I watched a couple of his welder comparison vids a while back and learned a little. But he was unbearable to watch so I haven't seen any since. He would drive me up the wall if he were a co-worker I had to put up with!

What's the rest of the story?