Hanomag 400c track loader

[Bruce C]

I have a hanomag 400c trackloader with press fit drive sprockets onto tapered splines and the drive sprockets are pulled off it and need specifications for pressing them back on. What distance tolerance of sprocket to shaft, ie are the sprockets to be level with end of spline or overhanging and if so by how much and what tonnage pressure recommended to achieve this position. I need to reessemble this machine and get it shifted from where it is. Be very grateful if anyone can help. Bruce C.

 

[banjodunn]

G'day Bruce if it is a tapered spline then it should have some kind of retainer on it ( bolt with large washer or nut ) just put the sprocket on and tighten the retainer, oh and :welcome:


Jon