Ground Clearance on BX2200
- Thread starter mthiel
- Start date
- Views: 1314
-
- Tags
- kubota bx2200
Worksmart
Silver Member
- Joined
- Jan 24, 2002
- Messages
- 226
- Location
- S.E. Michigan
- Tractor
- L6060, BX22, 1953 Farmall Super A, 1949 Farmall Cub, 1964 International Cub, 1966 International Cub, 1976 International Cub
<font color=red>When does this become a factor?</font color=red>
When the rock/stump you want to drive over is 6.8"./w3tcompact/icons/laugh.gif
If everything on your land measures 6.6" or less then the BX would/could work for you. I didn't take the time to measure everything at my place but my BX22 has been a dream/w3tcompact/icons/love.gif. C
When the rock/stump you want to drive over is 6.8"./w3tcompact/icons/laugh.gif
If everything on your land measures 6.6" or less then the BX would/could work for you. I didn't take the time to measure everything at my place but my BX22 has been a dream/w3tcompact/icons/love.gif. C
gobbler
Silver Member
I've run into clearance problems a couple of times with my BX. So far it's only been a problem when I have the rear blade mounted. It hasn't happened everytime, only occasonily. I have the Woods RB60 rear blade and it's got a 15" moldboard. I think that a rear blade with a 10-12" moldboard would suit the BX better.
I like the Woods blade, and found it to be heavier duty than the smaller moldboard blades I looked at.
Jim
I like the Woods blade, and found it to be heavier duty than the smaller moldboard blades I looked at.
Jim
Will_C
Veteran Member
- Joined
- May 24, 2002
- Messages
- 1,786
- Location
- Upstate N.Y.
- Tractor
- Kubota L3560, Toro 52" and 60" ZTRs, Kubota RTV 900
Mark, If you are going to spend much time off lawn, then the BX is probably not for you. I am a enthusiastic BX owner, but all my work is done on two parcels of lawn and a driveway.
The overall height of the tractor does present some raising problems with three point hitch implements. I have a stone rake for sale because the BX only gives me around 5-6 inches of clearance when the implement is raised. The newer implements like the King Kutter XB series should solve that problem.
The overall height of the tractor does present some raising problems with three point hitch implements. I have a stone rake for sale because the BX only gives me around 5-6 inches of clearance when the implement is raised. The newer implements like the King Kutter XB series should solve that problem.
The only issue that I've had with a BX22 is not with the tractor - but with the backhoe. I have to occasionally cross a stream with 3 foot banks on each side and the hoe will hit as the tractor goes up the other side. If it would have been mounted 2 inches higher it would be perfect. I suppose it really depends on your land and its features.
