12VOLTMAN
Member
I finally had time to get some pictures of my new 4120 today to post for you guys and about six feet out of the barn door the eHydro gave up and stopped moving. With only 18 hours on it now, this will be its second trip back to the dealer!
Soon after delivery I noticed it would stop moving in reverse and blink "Err03 - voltage signal out of range, or not calibrated" and it also had a hydraulic leak. The dealer picked it up and promptly fixed both issues. It ran fine throughout two mowings and now the new code is "Err14 - pump current. coil resistance too high or too low" and it will not move at all. I towed it around to the driveway where it sits waiting for pickup AGAIN! (Too bad the 8N sold so quick).
Looks like my reservations about all the electronics on todays tractors are well founded. I hope my dream tractor does not become a nightmare!
Has anyone else had issues like these???
Soon after delivery I noticed it would stop moving in reverse and blink "Err03 - voltage signal out of range, or not calibrated" and it also had a hydraulic leak. The dealer picked it up and promptly fixed both issues. It ran fine throughout two mowings and now the new code is "Err14 - pump current. coil resistance too high or too low" and it will not move at all. I towed it around to the driveway where it sits waiting for pickup AGAIN! (Too bad the 8N sold so quick).
Looks like my reservations about all the electronics on todays tractors are well founded. I hope my dream tractor does not become a nightmare!
Has anyone else had issues like these???
