GC2X10 picture help needed

[fozzy]

Can someone do me a favor and take/post a few pics of their lower lift arms on their 3pt hitch. I am suspecting I may have received the wrong lower lift arms as they do not clear the backhoe supports w/ a cat1 implement attached.

 

[VigII]

I've yet to use my 3 pt hitch but I've read here that your experience is a common issue with the GC2'X'10 frames. Some manufactures make the classI 3 pt hitch narrower to accommodate this. I'm sure others with experience will chime in soon.

 

[ray66v]

Some have reported the need to move the attachment pins to the inside on the implement, rather than the outside of the lift frame, to gain additional clearance.

 

[FDuce]

that's the issue I ran into here. I bought a trailer mover for a cat-1 and it was way too wide so I had to narrow it. I measured a width of 26" between the lower link ends will work well.