Ford 2600 Single Disc clutch plate in wrong?

[TEXFARMER]

Put a new clutch in my 2600 and I think I might have put the disc in wrong. Clutch works but engages/disengages at the bottom of the clutch pedal travel, but does fully engage/disengage. PTO works fine. Free travel is adjusted properly. Haven't run this tractor for over a year and I can't remember how it engaged before but I don't think it was as quickly as it is now and just seems to me it should have a little more travel. Is this an UNPROBLEM or do I get my jacks out and pull it back apart. I want to sell this tractor but I won't until I know I didn't screw it up. Thanks for any advice you can give.

 

[RickB]

If it were in backwards it probably would not disengage at all. New clutches always come in lower than worn out clutches. If it functions properly, adapt to the way it engages.

 

[TEXFARMER]

Thanks - I needed that. Just finished repainting it and I really didn't want to split it again. Thanks again.