Finish Mower Belt

[wmonroe]

I’m trying to find a replacement belt for my finish mower. It is an Edge Attachments MR-180 which is a rebadged Major Equipment model. Anyway the number on the belt is in the picture below. I’m having a hard time finding this belt and I’m not sure if I’m searching incorrectly or what but I was hoping someone had some insight. Thanks.

 

[big bubba]

i've always had good luck w/Jacks small engine not sure if your model is covered, but their data base is impressive. also Vbelt supply is good
go w/kevlar if possible.

Vbelts4less - Mower V Belts - V-Belts - Banded V Belts - Kevlar V Belts - Cogged V Belts - Industrial V Belts
Parts Lookup - Exploded Diagrams for Outdoor Power Equipment

 

[RickB]

AllPartsStore: Search results for

Put B74K in the search field. Excellent quality.

 

[wmonroe]

It says it is 5/8”x77”. Is the 77” the diameter or end to end length if you cut it and payed it out? I’m not very familiar with how belts are denoted.

 

[Big Barn]

On a 5/8” belt the inside length is most likely 74” and 77 indicates the outside length.

 

[wmonroe]

Ok so 77 would be the outside circumference. That sounds very close

 

[guitarman]

Yeah a BX74 shows to 77.6 oc or outside circumference and maximum width as 21/32 or .6562 inches

 

[wmonroe]

Thanks everyone!