Eric_Phillips
Platinum Member
I have a Farmtrac 270DTC. I can't seem to keep the turnbuckle on the right 3pt lower link from turning. I use a large crescent wrench to tighten the nut but it will lengthen while using implements. I notice this when brush hogging. I get everything level before heading out and after an hour or so I notice I am dragging the front corner of the mower when turning corners. I check and sure enough the turnbuckle has turned and lengthened the one side even though the lock nut is still tight. Any suggestions? Please tell me I need a hydraulic TnT, better yet tell my wife!
