My CX100 3 point would only move up or down a few inches at a time with the toggle switch. It had an error code A., so my dealer emailed a partial list and it said it was a short in the load pin, so I built a bypass wire with some resisters to meet the requirements. Error code A. went a way and now it has error code S. and the toggle switch is blinking and will not move the 3 pt. I plugged in the load pin again and it went back to code A. with the 3 point moving a few inches at a time again. Error code S. is not on the sheet I have or what the solution may be. I wish there was a way to by pass the whole mess and just have a manual lever. I keep wondering what code will appear next if I fix the S. code. Can anyone please help?
3-Point Hitch CX100 Hitch error code A. & S.
- Thread starter MagnessQH
- Start date
- Views: 3672
