I think the high pressure was in the FEL hoses not the tractor hoses so rocking the controls on the tractor had no effect. Since I am not in business with the tractor I could afford to wait rather than take drastic action . . . . Part of that was posting to the forum and that saved getting brutal with tools and lots of force when I didin't know what the problem was.
Loader Cannot connect Loader hydraulic fittings
- Thread starter Samwise
- Start date
- Views: 4093
timswi
Elite Member
- Joined
- Nov 18, 2008
- Messages
- 4,997
- Location
- Beaver County Pa
- Tractor
- Kubota BX23 TLB, Kubota RTV1100, Kubota Z724 & Polaris RZR 900 Trail
Rock the controls just prior to removal, that releases the pressure. You're correct, once disconnected, the controls won't help.
Fallon
Super Member
Correct & always best practices (make sure the engine is off first). But that often doesn't work. The flat face connectors on my SSQA snow plow & post hole digger suck. If they are warm at all (sun on black hoses, warm day, etc.) Its difficult if not impossible to to hook them up without cracking a fitting due to pressure in the lines. Doesn't matter how diligent I am when unhooking them.
I actually have a spare set of cheap flat face QDs I just got along with some small ball valves. Will plug the QD into the impliment & leave the valve closed when I unhitch. Open valve to bleed pressure, remove QD, then hitch up.
Pete6114
Gold Member
- Joined
- Dec 8, 2000
- Messages
- 383
- Location
- SW Ontario, Canada
- Tractor
- F2690(Sold) GR2120(Sold) L3240(sold) B1700(sold)
Seems to me that it was in a owners manual of one of the tractors i had. Not being pressurized also reduces fluid leakage to just a drop or two.
George the Beagle
Gold Member
It's a pretty common problem. I use a two inch 3/8" extension. Put it in the female end, wrap a rag around it, and lightly tap it once or twice with a hammer. Problem solved.
