ning
Elite Member
Does anyone here have BXpanded's "quick-on back hoe bucket connector" (for BH65/70/75/76/77/4672/4690B/750/751)?
Since at least the BH76 was made by Ansung, and my BH76 with a not-kubota brand was made by Ansung, there's hope that this attachment could fit my backhoe. I'd like to use a ripper tooth on my hoe, but suspect that I'd be needing to swap to a bucket fairly often to clean out the hole, and without a quick-on that could get tiresome.
If you've got one of these, there's at least two of us on this board who'd like to know:
(pic from BXpanded's site)
Since at least the BH76 was made by Ansung, and my BH76 with a not-kubota brand was made by Ansung, there's hope that this attachment could fit my backhoe. I'd like to use a ripper tooth on my hoe, but suspect that I'd be needing to swap to a bucket fairly often to clean out the hole, and without a quick-on that could get tiresome.
If you've got one of these, there's at least two of us on this board who'd like to know:
- inside distance between the walls (or, the width of the part on the BH that the pins go through)
- the distance between the pins (center-to-center)
- diameter of the pins
(pic from BXpanded's site)
