Box Scapper and scarifier shank question

[GaryDG]

I have the box scrapper and ripper teeth/scarifier shanks shown in the attached pictures. I believe the scarifier shanks go with the box scraper but I am not sure.

I know that "keeper pins" are generally used to keep the teeth in place but for these teeth and box scrapper what holds the teeth in place?

Thanks all!

 

[Botaskinner]

Hi there,
This looks very much like the retainers on my Land Pride.

Check out item 5 of this parts list:

Error

the notches in the scarifier engage the front of the slots in the frame, then you squeeze the retainer in behind it with a pair of Channellocks.

I hope this helps!

 

[Botaskinner]

BTW that's Land Pride P/N 305-111D if the above link doesn't work.

 

[bcp]

Or it might be this style. They drop into the frame slot opposite the scarifier notch.

Keeper Pins-For Slotted Notched Box Blade Ripper Scarifier Shanks-6 - Hardacrefarm

I don't know if they are interchangeable with the spring-V style, but both are intended for notched scarifiers.

Bruce

 

[Helitech]

Or it might be this style. They drop into the frame slot opposite the scarifier notch.

Keeper Pins-For Slotted Notched Box Blade Ripper Scarifier Shanks-6 - Hardacrefarm

I don't know if they are interchangeable with the spring-V style, but both are intended for notched scarifiers.

Bruce

That's what my old box blade used.

 

[GaryDG]

Thank you all on your replies. I'm pretty sure the ones to use are the 305-111D's. I went out to Land Pride and looked at a couple operator manuals and they had pictures showing the clips in place.

Thanks again!

Gary