Still BS regen issues. 1st time at the dealer they thought it was lack of fuel for the burners. Vented the fuel cap better. Still went into limp. The dealer then made a 400 mile round trip to put a smaller pulley on the air pump. Still did it and DPF got clogged. I pulled out the filter and was able to use the tractor for a few hours to load equipment as i was moving cross country. Then the area rep came from Oregon to troubleshoot before i left. Said the temps where not hot enough to regen and put a new DPF in. When i got it to Wisconsin, The dealer here installed new injectors for the burner and ran it for about 5 hours to see if it would regen properly which it did. This was in April. Been working good since. Went through at least 6 or 7 cycles without issue. Today i was moving logs and cutting trees. Backed up the the chipper to hook it up. Took me about 3-4 minutes. When i got back in the cab it was in regen with limp mode. Here is the video.....
LS XR3037C Emissions regeneration and limp mode issues yet again. - YouTube
LS XR3037C Emissions regeneration and limp mode issues yet again. - YouTube
