4200 Will not start
- Thread starter K3ZTJ
- Start date
- Views: 815
beenthere
Super Star Member
- Joined
- Aug 16, 2001
- Messages
- 18,554
- Location
- Southern Wisconsin, USA
- Tractor
- JD_4x2_Gator, JD_4300, JD_425, JD_455 AWS, added JD_455, JD_110, JD_X485(sold)
Welcome to TBN
Seems consensus of TBN has been that ether should not be used.
Sounds fuel related.
Can you give us some history of the 4200?
Status of fuel filter? Run out of fuel? Age of fuel in tank? water in fuel bowl? .. etc., etc., etc. So many things...
Seems consensus of TBN has been that ether should not be used.
Sounds fuel related.
Can you give us some history of the 4200?
Status of fuel filter? Run out of fuel? Age of fuel in tank? water in fuel bowl? .. etc., etc., etc. So many things...
Tx Jim
New Member
Welcome to TBN
X2 what beenthere stated about starting fluid. I only utilize starting fluid as a last resort for starting engine.
How long since fuel filter was changed? Do you have good fuel flow from tank to inj pump?? I've seen fuel passageways clogged in water separator housing. Is fuel tank venting??
X2 what beenthere stated about starting fluid. I only utilize starting fluid as a last resort for starting engine.
How long since fuel filter was changed? Do you have good fuel flow from tank to inj pump?? I've seen fuel passageways clogged in water separator housing. Is fuel tank venting??
Egon
Epic Contributor
If the solenoid does not clack when the key is turned you have found the problem.
It may involve the solenoid or a thermistor behind the fuse box.
On mine the solenoid gets filled with fluid And then will not work. Apply heat (heat gun) to the solenoid while pumping the priming pump and/or tapping on the solenoid usually works.
I do have a new solenoid in the tool chest with a thermistor. Haven’t found the location of the thermistor on the tractor though.
It may involve the solenoid or a thermistor behind the fuse box.
On mine the solenoid gets filled with fluid And then will not work. Apply heat (heat gun) to the solenoid while pumping the priming pump and/or tapping on the solenoid usually works.
I do have a new solenoid in the tool chest with a thermistor. Haven’t found the location of the thermistor on the tractor though.
