3 POINT HITCH

/ 3 POINT HITCH #1  

512high

Bronze Member
Joined
Mar 7, 2011
Messages
68
Location
Nashua,New Hampshire
Tractor
2011 JOHN DEERE 244J
Hi Everyone, I have a 2006 Kubota L4330-HSTC I use just for snow removal. Today I put the Ballast box on the three point hitch, and have a stupid question........on the three point hitch, the two lower arms (no top link) that attach to the each side of the ballast box, each arm has a "spring" lever on top , what do these do? They are "square" do they have anything to do with adjustments? are they suppose to "lock" Hope this made sense,,, thanks!
 
/ 3 POINT HITCH #2  
Sounds like a quick attach setup...there are 2-3 main brands etc...post some pictures and someone will have better info...
 
/ 3 POINT HITCH
  • Thread Starter
#3  
I mean a "spring" lever on top of each "lower" arm, the may be located 4-6" off where ballast box attaches, I will try to take pics Sunday, thanks for the quick response
 
/ 3 POINT HITCH #4  
You have telescopic lift arms. They make hooking up implements easier. They are nice if you are not backed up close enough or a little crooked.

Push down on the spring loaded part and pull out on the lift arm to extend them.
 
/ 3 POINT HITCH #5  
I mean a "spring" lever on top of each "lower" arm, the may be located 4-6" off where ballast box attaches, I will try to take pics Sunday, thanks for the quick response

No need for the pics. They are telescopeing lower links. They are designed to ease hooking up to your implement. Back up to within an inch or so of the implement pins. Press the levers down, use your foot on top if they are balky, then pull out the telescoping ends. Be sure to pull the pin out of your telescoping sway bars so that you can swing the telescoping lower link to the side to clear the implement pin. Once you are on both pins back up the tractor a few inches and you will hear a click click as both telescoping lower links lock back into place. Put the sway bar pins in the proper holes to center you implement. You may need to raise the lift after you get your top link on to get them lined up correctly. I can only imagine the unbridled joy you will experience upon executing this hookup.

James K0UA
 

Marketplace Items

500 GALLON FUEL TANK (A62131)
500 GALLON FUEL...
BTI TB 1280XL Hydraulic Rock Hammer (A61166)
BTI TB 1280XL...
2022 Schulte SMR-800 Multi Rake Landscape Windrower (A63118)
2022 Schulte...
2018 22ft. Tycorp Vector Belt VB-16H (A60352)
2018 22ft. Tycorp...
2021 Chevrolet Express 2500 Cargo Van (A61568)
2021 Chevrolet...
UNUSED ATS CMR1280 ELE.CEMENT MIXER (A62131)
UNUSED ATS CMR1280...
 
Top