RollTideRam
Veteran Member
I am ordering a Millonzi grapple for my 200cx. They offered to have it set up for the Deere QA and wanted to make sure of the measurements. I work 12 hour shifts and it is dark when I get home, so I'm not sure of my measurements. If anyone has ever checked them does this sound right?
Lower pins are 47 inches apart center to center.
Top "cuffs" are 40 inches apart and 14 inches above the pins.
Thanks for any input. JC
I'll be off next week to check again (in the daylight) if this is not correct.
Lower pins are 47 inches apart center to center.
Top "cuffs" are 40 inches apart and 14 inches above the pins.
Thanks for any input. JC
I'll be off next week to check again (in the daylight) if this is not correct.
