1900 FEL Plumbing........

   / 1900 FEL Plumbing........ #1  

Anonymous Poster

Epic Contributor
Joined
Sep 27, 2005
Messages
29,678
I have an '82 Ford 1900 4wd and just had a Westendorf front end loader installed. Love the loader but with the hyd hoses attached, my 3ph doesn't operate. Do I need to install some sort of pass-thru hose at the control or ball valve shut off in the pressure hose for each to work without disconnecting hoses each time? Thanks for any thoughts.
 
   / 1900 FEL Plumbing........ #2  
Fitz, I have a 1910 with a factory FEL. Look on the right side rail were the bell casting tapers into the transmission ( in front of the brake pedals) and you'll see the "Combination System Relief-Diverter Valve Manifold Assembly". It's a square block about 3-4" with 2 Allen headed plugs(these are auxillery ports and may be in use on your configuration) and between them and a little lower is a slotted bolt head. It takes a pretty hefty screw driver and you don't want to wallow out the slot . Turn this 90 degrees ( if its at 2 o'clock go to 10 o'clock or visa versa). RCH
 

Tractor & Equipment Auctions

2010 Hyundai Elantra Touring Sedan (A51694)
2010 Hyundai...
2024 Bobcat E35 Midi Excavator (RIDE AND DRIVE) (LIKE NEW) (A50774)
2024 Bobcat E35...
80in HD Tooth Bucket with Side Cutters ONE PER LOT (A52748)
80in HD Tooth...
EZGO GOLF CART (A50323)
EZGO GOLF CART...
2004 Freightliner FL112 Cab & Chassis (A47384)
2004 Freightliner...
2006 Dodge Ram 3500 Pickup (RUNS)(TITLE) (A50774)
2006 Dodge Ram...
 
Top