'00 4200 work light power feed

[KerryK]

\'00 4200 work light power feed

I am adding a couple small rear facing work lights to my 4200 - in the owners manual both the fuse panel and light switch list "work lights" entries.

I'm assuming (from other posts I've seen) that the wiring loom has a feed to the ROP area - can anyone confirm this?

On each side there are 3 wires that run up to the tail/turn lights, where those three wires come out of the loom there is a fourth wire (black) that is taped to a lavender wire that goes back into the loom. This is the same on both sides.

I couldn't find my tester last night - so I couldn't probe around on my own. Time to go to HF and buy another one /forums/images/graemlins/shocked.gif

I'm not putting much for lights on it an would prefer not to run a separate feed if there is already a switched/fused feed there (call me lazy).

Thanks all - Kerry

 

[DDT]

Re: \'00 4200 work light power feed

I found a wire under the seat, I think it was purple that I tapped into for extra lights. It is hooked to the switch in field possion ( lights on flashers off) hope this helps