protection

After several close calls mulching I finally got around to building this window screen taking advantage of a rainy spell. It's the upper screen. There was a plexiglass visor above the window that cracked and barely hanging on that I replaced with homemade steel version also. The old visor...

I have an NX5010 and have wiped out 3 flasher / turn indicators on trees while mowing. I found some aftermarket protection / shields but they are a little pricey for just some sheet metal. So, I hacked my own protection and haven't lost a light since. See the attached photo below. What I did was...

TL:dr = Check under the left side of your tractor to see where the fuel line exits the fuel tank. It is exposed without protection from brush and saplings. The long version: Thanks to all of you for posting here. I have been lurking and reading your posts and wish I would have done this before...

I use ear protection when operating lawn mowers, and brush hog. I have a set of electronic (?) noise canceling from Ryobi which has served me well for years. One issue is wearing glasses, as it allows noise in, which I have addressed by glasses placement. My neighbors, whom I purchased my...

Hi all. Does anyone running a drum mower for hay use a slip clutch coupler or an overrunning clutch for PTO/tractor protection? I'm a bit leery using nothing, no hole for a shear pin. I am worried about PTO brake as I understand it takes a drum mower a while to spin down. Any thoughts or...

Hello all, I am new to the forum and new to the world of tractors. I skimmed quite a bit in this forum in my research. Figured I would join once I had one. (skip to THE QUESTION if you don't want the yarn..) I recently purchased an LS MT468CPS with various attachments to start working on...