post driver

I have a 40 acre farm with about 15 acres fenced into a total of nine smaller pastures. I run sheep and cut hay and this set up actually works very well. It was fenced when I bought the property, but unfortunately it was fenced very poorly. Low quality fencing With t posts spaced way too far...

I have an older Shaver HD8 post driver hooked up to a Ford 4000 that is not working. The cylinder does not want to extend on its own. If I push up helping it a bit and pull single spool valve lever back the cylinder will lift slightly, approx. a couple inches to a foot. After that when I push...

Put this together to stop the constant leaking around the return hose on my shaver post driver. My kubota just has a plug, no threads. Driver dumps into the 5 gallon bucket. Bucket drains into tractor. Bought a bulkhead fitting from tractor supply. Bucket and old garden hose were typical...

Notwithstanding that the driver is made in China, the 350E I just purchased is one of the most satisfying devices I have ever bought. Montana's larger drivers are supposed to be made in the US. I bought the forklift frame mount model and it will need a stopper plate to keep the bottom from...

Anyone here using a post driver with their tractor? I recently acquired a horse farm and would like to install more pasture. Made the decision to purchase a post driver for my tractor, (2019 RK-55), and am looking for advice on selecting the right driver. Currently focused on the Shaver HD-10...

I'm considering installing a third function valve with the intent of getting something like a Danuser T3. Might get a 3 pt one like a Shaver. I don't much experience with any of those, all I know is I'm too old to be doing this stuff by hand anymore, and augering is taking too dang long. I'm...