I bought a 97 1235 with 91 hours on it two years ago when I bought my property. I've used the heck out of it with little to no issues until late this summer, now at 250ish hours.
The HST seems to "slip" into gear from neutral. It has the neutral safety switch so unless I am in the seat, it will...
Noticed my mid PTO was leaking fluid. Found the 2 bolts securing the cover plate were loose so I tightened them but leak persisted. Removed cover plate and saw that there was not gasket or seal present. Assumed one was needed so I bought and created a gasket for the cover plated. Installed cover...
We would like to extend a very hardy THANK YOU to all who made suggestions on how to repair our Massey Ferguson 1235. After some ado with a hydraulic shop, we finally have a line to properly fit. It is installed and the tractor is no longer bleeding power steering fluid. We wish you all happy...
ello and thank you for allowing me to join your group. I am looking for some help locating a power steering part for a Massey Ferguson 1235 series. O.E.M. number is 3607333M91 , this is a steel line from the Iseki pump to the gear box. To describe it is as follows, Pump end round with 4 bolt...
Hello and thank you for allowing me to join your group. I am looking for some help locating a power steering part for a Massey Ferguson 1235 series. O.E.M. number is 3607333M91 , this is a steel line from the Iseki pump to the gear box. To describe it is as follows, Pump end round with 4 bolt...
Hello and thank you for allowing me to join your group. I am looking for some help locating a power steering part for a Massey Ferguson 1235 series. O.E.M. number is 3607333M91 , this is a steel line from the Iseki pump to the gear box. To describe it is as follows, Pump end round with 4 bolt...
Hello everyone. 2 years ago, I inherited from my dad a mid 90's MF1235 tractor which runs fine with about 800 hours on it. He had a MF1216 backhoe attachment which sat for about 10 years and I didn't think I would even use until my septic leach field failed this year. So after hooking it up...
Good Morning Everyone, I have to say this is a top notch forum and a wealth of knowledge for just about any tractor owner.
I have a 95 Massey 1235 Compact with a hydrostatic Tranny and need to see if anyone can give some advice. We were doing some dirt work in the backyard recently over the...
We own a 1996 Massey Ferguson 1235, Last year we had a Woods Front mount bucket loader installed at a local dealship. The hyd. lines to the loader attaches to 4 factory mounted quick couplings behind the seat. The hyd valve is a factory mounted joy stick.
Our problem: The loader does not seem to...
I have a MF 1235 3cyl. diesel iseki and it only has 10 lbs of oil pressure. My question is: What is the operating oil pressure supposed to be? I have changed the filter and put in a new gauge.
Where could I find a service manual for my MF 1235? I've looked all over the internet and I can find them for similar models (MF 1225, MF 1240, MF 1230, etc). Jensales has them for those models...do you think they're "close enough"?
I think I need to replace front bearings as I'm getting a...
The front drive shaft on my MF 1235 sheared off about an inch back from where it goes into the front axle. For the life of me, I can't figure out how to get the shaft out of the axle! There was a snap ring in there that I took out but I can' t figure out what purpose it serves. There was also a...
The front axle started leaking on my MF 1235 where the right side wheel arm rotates(kingpin?) after I ran into a log in the yard. Don't know if I've done a good enough job of explaining where it is leaking, but can someone tell me where I start with this job and what is causing the leak? Bad...
My MF 1235 with 450 hours will not start without using the glow plugs and it just pours out black smoke when I try to start without the glow plugs. It runs well and does not smoke much at all once it is started. I have new air filters installed, so that is not it, and I understand that the black...
My MF 1235 with 450 hours will not start without using the glow plugs and it just pours out black smoke when I try to start without the glow plugs. It runs well and does not smoke much at all once it is started. I have new air filters installed, so that is not it, and I understand that the...
I'm looking at two MF tractors at two different dealers. Not a whole lot of difference on the surface, but hopefully you guys can shed some light on the differences and help me decide!
1. MF 1235/FEL/Hydro with 900 hours. Tractor is in nice shape and I can pick it up for $11K out the door...
\'97 Massey Ferguson 1235 Price?
Yesterday, we bought a '97 MF 1235 at a tractor auction. It has a 72" belly mower, 360 hours, and in great condition. I'm trying to find out how much this would actually cost. Is there any on-line tractor "blue books", or can anyone out there give me an...
I recently discovered a MF 1235 tractor that is 1 to 2 years old and has seen only a little over an hour of use. I understand the owner bought it at an auction and it is gathering dust in a garage.
I'd like to make an offer but need some expert advice as to what this tractor is worth.
I will...