kukje

Did a compression test yesterday on my 2011 Branson 3120R with the A1700 engine. LOWEST reading (#1 Cyl) was 465 psi! Thanks to this forum I learned the factory numbers were like 497 psi so WOW! Engine has approx. 1700 hours and is used not daily but regularly to brush hog, load round bales...

Greetings. Anyone out there who can explain the difference(s) in these engines? Thanks in advance.

Greetings, was hoping to see if anyone has information on what service/parts manual required for a 2023 Branson 3515H. Are there separate manuals for the TYM 3515H? I'm guessing Kukje A1700N4/TYM T1700N4 engine manuals are included with Branson/TYM 3515 manuals? I seen a few other posts that...

I have a McCormick X1.35 that will not start on low idle, meaning I have to raise the idle lever so that when it does start, it starts at 1500-2000 RPMs range. I thought it could be the electric fuel lift feed pump, so I replaced it with a new one, and it is still doing the same thing. In...

I have a 2020 X.135 with the Kukje engine. It has 250 hours on it. I know in the beginning, I was not doing what I was supposed to do by keeping it at a higher idle. I had performed a few regens on it and never had an issue. However, this winter, it started to "de-rate" itself for any use, PTO...