kubota m8200

Hydraulic remotes in my M8200 have always worked fine. But, about 5 weeks ago, the right remote began "slowing down". It works, but goes very slow. So, if the lift function hose is attached to the right port - its lifts the disk very slowly. If I switch hoses then the lower down function...

The specs show the LA 1251 to be the matched loader. But TractorData shows that the LA 1301 will also mount on the M8200. Anyone have any information or experience on this topic. The LA 1251 is almost impossible to find but the LA 1301 seems more available on auction sites.

We just completed changing the clutch on our Kabota tractor. We cannot get the tractor to start. It turns over just fine. I’ve pumped and pumped on the pump above the fuel filter. Filled the bulb up just fine with diesel fuel. That’s the end of it. Just don’t seem to getting any fuel to the...

I have a Kubota M8200 and it only has two rear hydraulic valves (which are in use now for a front hydraulic 3 pt hitch). I wanted to an additional hookup to the rear, but I don't know a thing about what parts of kits I would need, and if the M8200 can handle 3 rear hydraulic valves? Can someone...

PTO unresponsive, kicks in when it feels like it not turns off immediately. Oil and filters changed cab control checked and OK. Any ideas?.

There are 4 pulleys, drive pulley, A/C pulley, tension pulley & a small idler pulley. I do not now which side to put the belt on this pulley.

Hello all, I have a 2003 Kubota M8200 Narrow tractor and found a hole in the top of the, I'm assuming, transmission case. When sitting in the seat this hole is located between your legs, on the left side of the case, toward the rear. It is not threaded and looks like a hole that a dip stick...

I've got a 4WD Kubota M8200 and the steering is really choppy. I've checked to make sure that there's no obstructions or anything obviously wrong with the steering or with the hoses and without breaking into it, I'm not sure what else to check. Anyone have any ideas? Thank you

New to site. Working on a m8200 narrow that has a dead short In the 4x4 circuit. I have narrowed it down to the harness that runs over the top of trans to the Hyd top. Wiggled all wires and no difference in short. Has anyone had an issue with shorted solonoids for 4x4? Any help would be nice...

Can anyone give me a price estimate for a 2000 Kubota M8200, cab heat/air, 4WD, loader, with 2100 hrs. Everything seems to be good mechanically. Are there any major mecahnical issues that I need to be aware of for that model?

I am having trouble with my tractor. I don't know if the transmission is slipping or if my clutch is burnt out. I was told by the dealer that there is an inspection plate behind the clutch but I can't seem to find it. Is there anyone out there who knows where it is exactly? they told me that if...

I am trying to decide between the JD 6220 and the Kubota M8200 both with MFWD and cab. Any advice? The Kubota is a lot cheaper and I am wondering if the JD is worth the extra money (around $10,000 difference). Thanks! Keith