ford 1320

Hello everyone, I have a 1989 Ford 1320 tractor with a manual transmission, and I’m having a problem. I have more or less the skills of a mechanic, and I bought the tractor’s workshop manual, but I don’t really know where to start. I have an intermittent hydraulic problem that’s getting worse...

I have connected a spool valve to the pressure port and return port on the manifold of my Ford 1320. (1988 with 800 hours) This diverter is on the RHS, just a little below the hydraulic pump. The spool valve is open centre. According to the user manual, I have rotated the control screw to...

Need a new seat for a new to me Ford 1320. Anyone have good luck with any particular brand/type. Thanks, Mike

I'm considering purchasing one of these. Both are in good condition with the ford being slightly more power and the yanmar giving me 4wd. Both have decent loaders on them... I've never had a little tractor this size... I'm thinking the yanmar 4x4 will crawl around in the wet conditions this...

hello gang, just bought this little ford 1320, 4x4 with a koyker 155 loader. really clean little machine. previous owner only used it to blade his driveway. hydraulics were making kind of a howling or grinding noise that seemed like it was coming out of the manifold diverter block. also the...

Hello, I have seen many posts on this topic but no clear resolutions, hope you can help I have a 1990 Ford 1320 Diesel 4x4 tractor that will not start and the dash lights intermittently have no power / do not light up What happened / what I致e done: -I was working in the field and...

I have a 97 Ford 1320 that wont start. I just recently acquired the tractor. Apparently it worked while the previous owners were living on the property. I checked all the basics, has fuel, replaced the battery, air filter oil, and checked all other liquids. After checking everything and...

Hi i've got a Ford 1320 and recently noticed in the last month that when I start it it tends to start hard. I noticed today that the glow plug light on the dash doesn't light up at all now when the key is turned on. When attempting to start the tractor it smokes and once it starts a lot of...

New tractor owner here looking for some seasoned advice. I have been trying to find a 20-30hp tractor on craiglist for sometime now FEL, 4x4 with no luck. I came across a Ford 1320 Hyrdo with 2050 hours on it, newer King Kutter 4' tiller and rear blade for 7k. Tractor did not smoke but seemed...

Does anybody have a used Fuel injector pump for a ford 1320 tractor ? My pump has a some broken parts, and was full of water and dirt, so its not really worth for me to rebuild it.

Hello, first time on this forum. I have an early approx 1994 modle 1320 New Holland Utility Tractor. I live in Eastern Canada and have small acreage. I want to add hydraulic remotes. Tractor is stock and has power steering.Also it is hydrostatic. Any help with this will be appreciated. Thanks...

Hi!!! I am looking for a wiring diagram with fuel and temp gauges for a Ford 1320 Tractor. I have found wiring diagrams but they don't have the fuel and temp gauges .

I have been looking for a smaller 4X4 tractor to be lighter on its feet than my John Deere 302A. I found a Ford 1320 at a local New Holland dealer but before i go and look at the tractor i have a few questions here. One of my main tasks with the tractor will be snow removal. I do not think my...

I am going to buy a tiller for my Ford 1320 and need some advice about what size tiller my tractor will handle without being totally bogged down.

Hi All, it is with great sadness that I post that my late 80's Ford 1320 needs a complete long block engine overhaul. Problem with that seems to be from my searching that parts for the shibaura engines are difficult to come by at the very least. The tractor has a FEL and backhoe and has about...

Ford 1320 only makes one click then wont do any thing after taking out battery and reinstalling. Charged battery overnight. Same result. Dash lights came on before trying then after the click...nothing. replaced battery terminals and have 12v at starter. ( I accidently reversed polarity on...

I just encountered a problem with my old ford 1320. I have a hydrostatic drive, and today I jumped on and have no return at all to the neutral position on the forward/reverse pedal. I poked around, and spotted this little shock absorber thing, and pulled it off. Is this what is supposed to...

I have a 1320 and I was wondering if I could install hydraulic remotes on this tractor since it did not have them on it when I purchased it? Thanks for any help

If someone on this forum has a 1320-1520-or a 1720, I really need for someone to operate the switgh key to the run position and see if the fuel cutoff solenoid will operate, having prblems cranking mine and I think the sw is bad, I would really appreciate it,

Looking at buying a 1993 1320 Ford, only thing is it does not have a FEL and may have to put one on. It all depends on costs and I have no idea how much it would cost to put a FEL on it. Mostly likely it will be too much but still it's a possiblility.

I have a Ford 1320 over 20 years old. The tractor would not start and I replaced the old battery, checked the fuses, cleaned and tightened but the tractor will not start. I have read the manual and can't locate a trouble shooting check list. I would like to do the repair myself if I knew what...

I have searched high and low for the answer to this, which my local dealer had no interest in answering since I was not buying any parts and will therefore never buy parts from them, but: Are the rear rims between the 1320 and 1720 late 80's early 90's tractors interchangeable? I have someone...

My fuel injectors are leaking slightly around the copper gasket that seals them to the engine block. I picked up the new gaskets last year, but haven't gotten around to installing them. This might be a good job for the weekend. I was wondering if anyone had experience removing the injectors...

Looking to buy my first tractor loader. Definitely want hydrostatic trans for the work I'll be doing. Saw one advertised as such. Is this a Kubota with Ford's name and paint? It is 4wd and hydro trans? Good machine/any one have knowledge? Thanks Matt

New to this forum, hope this is in the right category. I am looking for a source for a used Ford rim for a model 1320. Rim is stamped 11X16. Center (hub) hole is 4-1/2". 6 bolt, diameter of bolt circle is 7". Anyone know of a source or someone parting a 1320 out? Thanks for the help!

Well guys I need to price my Dad's farm eqipment to sell off since he's gone now. Here's a list. I think the tractor is about an '84 or '86 and the implements would be the same. Everything is barn kept and sometimes too greasy. Ford 1320 with 6-700 hours Ford 105A tiller Bush hog squeeler 5'...

I've never owned a SCUT. I MAY buy one to do some finish mowing. Does a Ford 1320 (20 HP, 17 PTO) have enough HP to run a 5' finish mower (3 pt connected)? Thanks in advance...

Hello all, I have just recently purchased a 3pt hitch log sptitter for my 1990 Ford 1320. I have a Ford backhoe for it and I thought i could run the hydraulics for the splitter through the backhoe hydraulics. It works well except for the fact that the 3pt hitch doesnt go up. So i have to...

Hi All, Buddy of mine saw a 1320 that he might be interested in but wasn't able to talk to the compact tractor sales guy until Monday. Can you give me a idea of what it would be worth so I can tell him before he gets a call on Monday. Has looked around it and looks ok other than fade...

Does anyone know what model standard filter replaces the oil and hydraulic filters? I don't have a Ford Tractor dealer in my area any longer. I have a 1991 1320 HST.

I have a '89 Ford 1320 that I have used to cut 3 acres for 14 years. I have recently started building homes. I want a FEL and a box scraper for clean-up and light landscaping around homesites. Am I stupid for thinking of putting a loader on this little tractor? Should I look for a 30-40 hp for...

Hi, I currently have a Ford 1220 and i would like to go to the next size bigger for certain reasons. I found a 1995 Ford/New holland 1320 4wd turf tires , hydro, 60" mid mower with 521 hours the dealer wants $10,500. Is this a good price?? The tractor has no dents or scratches in it!!!, Just...

Hello tractor experts. I'm new to this forum and to tractors in general and have a question regarding a tractor I am getting ready to sell. I would like to know how much I can expect to get for the following: It's a 1989 Ford 1320, looks nearly new (garage kept since purchase in 1989), and...

Hello, I am going to part out a Ford 1320 4WD tractor. It has a blown engine, but the rest of the tractor is intact. It has new tires, the rears never mounted and the front less that 100 hours. I am picking up the tractor on Sunday and it will go to the scrap yard on Monday. If anybody needs...