bush

I have an old 5' brush hog I use for mowing rough stuff. I do not know the maker. My question is are the blades and bolts generic for these machines. My blades measure 24"

I running 6 ft woods mower . When I am mowing and make a turn the sides dog into the ground and removes a strip of grass. I levaled it side to side . Haveam it pitched higher in the rear. I've tried raising the mower up thinking that maybe I'm mowing too low , but then it doesn't cut very well...

I am running 6 ft woods mower . When I am mowing and make a turn the sides dog into the ground and removes a strip of grass. I levaled it side to side . Have it pitched higher in the rear. I've tried raising the mower up thinking that maybe I'm mowing too low , but then it doesn't cut very well...

Good morning, is it normal that these blades be loose? I know nothing about this, I need one and it’s been sitting The bolt/ nut is tight, just sloppy from wear. Not stupid loose in my uneducated opinion but definitely wobbly. Someone has just abused this thing Thanks

G’day Tractor Forum, I've recently picked up a Toro Z287L with a seized FH680V engine and a bad deck. I've cleaned up the engine, honed the cylinders, and soaked the heads in ATF. I reckon it'll run fine with new gaskets and oil. The deck is a non-original 52-inch replacement, but it’s beyond...