alamo
-
Alamo Mott K72
I recently acquired a K72 and I’m having some trouble cross-referencing a few bearings and seals. So far, I’ve identified several of the parts, but I’m still having trouble finding the rotor shaft seal. The measurements I got are approximately 1.82" OD x 1.37" ID. I’m also not sure of the...- adler234639
- Thread
- Views: 520
- alamo flail mower mott
- Replies: 1
- Forum: Attachments
-
S
Alamo flail mower questions.
Bought a used Alamo74 cutter. One of the features is dual rear laminated, bushhog type trailing height gauge wheels. It’s also has the roller bar. The roller bar has some perforations from rust where it was sitting on the ground. Question, do you really need the roller bar with wheels? Patch...- Smokeydog
- Thread
- Views: 8096
- alamo flail flail mower mower
- Replies: 14
- Forum: Attachments
-
Flail mower bearings
Hey guys, I’m rebuilding a Mott 60 flail mower I picked up for $200. I’ve priced out the parts I need and it’ll run me around $650. The bearings and housings are almost $160 per side. Ive cleaned everything up as best I can. My concern is on the cuttershaft ends. One side looks good but the...- Skramps
- Thread
- Views: 3074
- alamo diy flail mower mott rebuild repair
- Replies: 10
- Forum: Parts/Repairs