I searched everywhere and couldn’t find where the electronic thermostat lives in my UW56!
Today I started tearing things apart, and noticed a clear window at the bottom of the heater/blower plenum. When you power up your Toolcat and turn on the AC, you can see fault code pulses from a red led...
2007 toolcat, good condition, low 1870 hrs. I replaced a few tie rods that were looking worn recently and then added brand new turf tires and had them foam filled so no chance of flats ($3000 total cost). Comes with standard toolcat bucket. Has cab with Heat and AC. Dump bed rated to 2k lbs. Has...
In January I had a front motor hose brake , left the machine there for 1 month in the snow, then patched up the hose with a screw-in connector. In May, we retighten the connector as it had lost all the oil. I then added Mobil oil and restarted the machine. Moving sand for about one hour, it...
Hey there hoping to get some insight my tool at 5600 has a intermittent drive problem all the hydraulics work but it will only drive 10% of the time and when it does drive it's very jerky and comes to complete stop while still while still on the gas pedal
Anyone else have issues like this?
In January (-20C) pushing snow, one of the front right behind the wheel hose broke on the 90 degree iron coupling. All the hydraulic oil ended on the snow. The 5600 stayed there for about one month. I put a screw on hose coupler and changed the other end. Put oil back in and was able to use the...
My Fender lights on my 2006 toolcat do not work. I have tested the bulbs and they do work off another 12v source. All fuses in the passenger side fuse panel are intact and working.
All other lights are working. Is there another fuse that is buried somewhere that is missing? Switch still...
Have a 2004 Toolcat 5600 and am looking for some rigid hydraulic hosws, hydraulic body valve and a solenoid.
Any ideas where to find replacement parts ?
Got a little too friendly with a tree and unfortunately broke the back, smaller piece of glass on the hinge side that opens. Bobcat only shows a replacement for the entire fricking thing for near $600 which us crazy! Part #7103606 — There doesn't seem to be a logical reason why they wouldn't...
I've got a Toolcat 5600 that can barely drive yet shows no error codes.
Boom seems to work fine although I haven't tried operating it with a loaded bucket.
I jacked it up and rear axle seems to move slower than the front axle.
Read on this forum that disconnecting rear axle speed sensor was a...