4720

I have a JD 4720, noticed the left front wheel was leaking real bad. Found the hub was moving up and down, which destroyed the seal before any other damage could occur. After pulling off the hubs I found Left side hardened washed in pieces sitting in the gear area, Right side hardened washer is...

I'm considering upsizing from my 2038r to a 45/4720. I have read (here) about the timing cover leaking and being a time consuming job to replace. Is this issue widespread? Or just enough to make a few cases? Is there a year Deere started using gaskets instead of sealer? Did it resolve the issue...

Can you tell me what Model # loader you have on your Tractor?

Can anyone tell me if a Bush Hog 2846qt FEL will fit my JD4720 2011 model?

I HAVE A 2003 BRANSON 4720 . I REMOVED THE HYDRAULIC HOSES TO INSTALL A 3RD FUCTION FOR GRAPPLE. SINCE THEN THE REAR HYDRAULICS HAVE NOT WORKED . SO I PUT EVERY THING BACK STOCK AND IT STILL DONT WORK. MORAL OF THE STORY IS I DIDN'T TAKE ANY PICTURES. I NEED SOMEONE TO TELL ME HOW TO ROUTE ALL...

Hello. New member here. I have a JD4720 tractor with a cab. If I pull the transmission dipstick when it’s warm, there is a large release of pressure. I don’t think this normal. Is there a vent that could be plugged? If so, where is it located. Thank you.

Hi, Does anyone have guidance for removing this screen. I have removed the two bolts from the L Bracket as manual instructs but cannot figure out how to remove the bracket from the housing that houses the screen? Any guidance would be greatly appreciate. Thank you, Saxe

I've owned a 4720 with cab for 15 years that I still have. A couple of years ago, I decided that I needed a second tractor that size and bought a new 4066R with cab. One thing that bothers me is that the lock lever for the joystick on the 4066R protrudes out from the right console a couple of...