Search results

Hey folks - I'll try to make this as succinct as possible. Did my 50hr service a few weeks ago, it's been 90% loader+tiller (w/hyd toplink) work since getting the CX in Feb. Installed the backhoe last week in anticipation of some trenching. Cycled all the cylinders, re-checked hyd fluid, all...

Thought someone may find this bolt info useful in the future. Links to McMaster PNs below. On two separate machines, brand new, half the bucket tooth hardware was destroyed (cross threaded) on removal. Combination of cheap hardware, black oxide finish (which gets compromised almost immediately...

I'm about 6' and have to have my suspension seat raised all the way on my CX. As such the loader valve control arm is about 4-6" shy of where I naturally grab for it. Does the knob just twist off, or are they a friction fit? No set screw that I could see. Gave it a good twist, but because I...

Hey all - I don't have much hydraulic experience and am a bit confused about what exactly is on my tractor and my options. It's a CX2510 with backhoe. There are two ports on the rear. To operate the backhoe I move the fender lever to "A". There is a B position, as well as center. It is not...