Search results

Like new. Selling land/farm and starting to sell equipment. $2500 firm. PM for more info or phone number if you have questions. Thanks. $3

Selling land/farm so starting to sell equipment. Excellent condition, just needs a wash, but no damage and little actual use. $2500 firm. Can load on your trailer. PM for more info or phone number if you want to discuss. Thanks.

I had bolt on hooks on my MX5800 and was planning to do the same on my new M7060. The buckets are of a different design and I am having a hard time figuring out where best to place them. There is a "boxed" in portion, but it seems fairly thin by my standards to bolt the hooks. I am just using...

So I am down to final decision making on a 75HP utility tractor. Going with Kubota and am really trying make the correct decision for me. I really dislike paying for items that I don't need. E.g, a training seat. It is just me and my dad running the tractor and we are not in it for hours on...

I am down to the nuts and bolts of buying a new 70-75HP tractor. Basically down to Kioti 7320, Kubota 7060, and maybe a NH Workmaster 75. I didn't really notice it before, but they all have quite different engine displacements. Kioti - 149ci/2700 rpm Kubota - 203ci/2400rpm NH -...

So another Rotary Cutter thread, but not really about size or any of that. I want/need a medium duty (rated at 3") cutter to clean up some woods and do some general tasks. I don't plan to cut much that is 3" and most likely not much over 2", but I want over built since I plan to have it for a...

So I have read and re-read many posts on here and other places about different rotary cutters and still can't decide what to do. Always good to get some educated opinions from the forum on this. I am looking at a fairly broad spectrum of cutters and any of them will probably serve me well, but...

So I put in 300 tons of rock yesterday for my new driveway. 2-3" base rock 6" deep with 3-4" crusher run on top 10-11' wide. I expect it will naturally end up running out to 12' over time. It still needs to settle and be run over, but I need to get a land plane to run over it quite a bit...

While I am pretty good at understanding most things, Hydraulics are still a bit of black box for me. I know that my MX5800 has a total Hydro system gpm of 14.4 (9.5 for pump flow and 4.9 for Power Steering). I plan to purchase new Danuser hydraulic Auger, either EP6 or EP10. The EP10 says...

I am in the market for a Rotary Cutter for my MX5800 with 50 HP PTO. After some research I was planning to order a Woods BB720 (6'). Just looking at CL and there is a BushHog BH27 (7') available with limited use which has a good price. My concern is the BH27 may be a bit too much cutter for...