Search results

I ordered speed related ball bearing and bushings will replace for a new reference point. In the mean time I did grease/oil all related items seems a bit smoother. I did discover the cruise control handle interferes with the the 2 spd hydro handle. CC was pushing fast speed toward neutral. In...

about speed control, when depressing the pedal there's no resistance until these settings, 1st pic is fwd, 2nd reverse, all connecting points are tight/fine. Is this a matter of adj the rod length via 080?

Any thoughts on theses rear pics? I've ordered new matching tires, dust covers. Also, the upper/lower post bushing replacements are on the way.

Both are in my basket as well. I didn't force the steering shaft up just tried pulling and it wasn't budging. Have 2.5 tears in the right shoulder pretty much pain free but I gotta pay attention certain uses. My guess one or both of the bushing are causing resistance. The rear, too clarify...

Thanks for your reply, hrs 1438, I did order a hard copy WSM should arrive today. In the meantime I decided to removed a few items to get a better look. The steering ujoint needs replacing since I'm in there 2 bushings. Tries to pull the shaft up doesn't want to budge and tricks there?

trying to recommission an F3060 2 areas of concern. F/R Pedal, doesn't feel like it centers properly, there's a bit of jerk moving from F/R manually, doesn't quite return to neutral no pedal one must tap to disengage hydro/complete neutral. Seems like one must depress pedal too far fwd to before...

I did not disconnect. I will try to disconnect and reconnect as well as back and forth a few more times.

NH TC 25 All was well prior to a hyd fluid service this winter. Just scooped up a load tilt the bucket back and it falls slowly down. Dumped the load it still falls but at a slower rate. Checked the fluid level and for leaks they are fine. Ran the bucket fully in all directions all is fine no...

Start up the unit runs perfectly temp is good, fan runs, 20-30 minutes starts to buck apply more throttle all is fine, 10 min later temp rise, fan slower, 5 min later not enough power to overcome bucking, fan stopped. I don't read any voltage at ele connector to fan, fan speed doesn't changed...

Can anyone identify part numbers of the hoses at the bottom of the pic? These route below the drivers side cab. Also, hose size and if possible connector particulars? It appears to me that the connectors are field installed unforgettably they are leaking at the hose into the connector. Not sure...