Search results

I have a MF 50 that the power steering has come apart on. The problem is that the power steering hydrolic cylinder has come loose. The pin that holders the ram in the anchor block has sheared. 1. I need to know the proper names for the pin and the anchor block. 2. Where is a good source...

I added a set of gages to my 4540. I got tired of the idiot lights and so I added the gages. Just something to tinker with.

I have a 2016, 4540 four wheel drive with a loader. I have been trying to find a radiator and/or block drain with zero success. Could someone give me a detailed description of where they are located? A picture would be nice as well. I looked in the owners manual (?) with no luck.

I had a little problem with the quick disconnects for my 4 in 1 bucket. They were sticking up just behind the bucket and just waiting to get broken off by a piece of fire wood or a tree limb. I decided to make a little modification and this is what I came up with. It is just a piece of 3...

I would like to know the location of the water temperature and oil pressure sensors on my 2017 4549. Pictures would be nice if you can get them. Thanks

I have a new (bought it in February 2017) 4540 that has the check engine light on. I have tried 3 OBD II code readers on it and none of them will tell me what the code means or turn the check engine light off Can anyone tell me what the P1801 code is and how to turn it off?

I got a check engine light on my 4540 today. I guess it is time to get a code reader. I have one that I bought for my truck about 16 years ago but it will not read the codes on the tractor. NOTE: I DO NOT have a smart phone but I DO have an iPad. I need advice on what would be a good OBD...

I am coming up on the 50 hour service on my 4540. I am concerned about getting the spin on filters off. Everything on that tractor was put together by Magilla Gorilla. (It took a 2 foot breaker bar, 3/4 inch drive, with a 3 foot pipe to take the lug nuts off.) Can anyone give me some helpful...

I have a Model 4540, 2016 model year tractor. Can someone tell me where the Air Intake Heater Relay is located?

I received the new orfice fitting today and I was very surprised. Here are some pictures of the old one and the new one. As you can see, the new one is way smaller then the old one. Here are the numbers: Original orfice: 0.225 inches a #2 drill New orfice: 0.041 inches a #59 drill...

I received this today from my sales rep. I hope all is well. Please see the attached photos. This is the fix for your issue. It is a replacement orifice that goes in the top of the radiator to the left of the fill neck / radiator cap. It is a matter of remove the hose clamp; pull off the 3/8...

Over the past while, there has been much discussion about the cooling system on some of the Mahindra tractors. Some have said that the problem is in the temperature gage, others that the cooling system is oversized, and still others that coolant bypass hose is to big. This is the email that I...

I have a new 45-40. It is my understanding that some models of Mahindrs have an OBD connector someplace. That is my question where is the OBD connector?

In my owners manual on page 79 top of the page it states that the oil reservoir is common for the transmission, hydraulics and steering. A little farther down the page it shows a picture of the transmission drain plug, labeled C. It seems to me that it would be a little more convenient to use...

I have a new 45-40 tractor that I am still trying to figure out what everything is. I found two pipe plugs that I think drain the hydrolics but I am not sure. One is located just below the PTO. The other is other is up under the tractor by the hydrolic screen. I was also wondering how...

I just purchased a new 45-40 tractor. I have been looking at how the seat is attached. I can not figure out how to remove it. I want to see if I can make the seat tilt forward. This would provide some protection to the seat from rain and also allow me to shield the seat from the sun. Try...