Search results

Results 1 to 10 of 10
  1. T

    The guy that put the engine internals together says "The rings are not seated yet end the smoking is normal. Just give it a couple hours of work"

    Check the oil pump pressure relief valve, make sure it’s not stuck open or missing
  2. T

    The guy that put the engine internals together says "The rings are not seated yet end the smoking is normal. Just give it a couple hours of work"

    With new bearings, machined crank and new oil pump, it should have around 100 psi of pressure. 15W/40 oil? Sounds like something was left out. Maybe half of the bearing? I saw that in a new short block from Ford, or an oil gallery plug?
  3. T

    The guy that put the engine internals together says "The rings are not seated yet end the smoking is normal. Just give it a couple hours of work"

    The Ford tractor rings are very hard. You MUST put a thermostat in it and run it hard for a while after it warms up fully. I used to Dyno engines at the dealer I worked at years ago. I think it was no load for 30, 25% load for 30, 50% load for 30 minutes 75% for 30. I am not sure on the time but...
  4. T

    MF 273

    Does anybody know if a Massey 273 is the same tractor as a Landini 6830? I heard that it was and I'm trying to help a friend with Hyd. problems. I need a parts breakdown and or a hydraulic schematic. Gary
  5. T

    Loader  Dual SCV joystick

    Can anyone tell me if the joystick retrofit # RE222004 is better than the original? The original joystick housing part #RE55055 is plastic and is broken. If you order Basic control unit # RE187108 it reverts to the retrofit kit RE222004. All I need is the housing Part # RE55055 But I don't want...
  6. T

    Aftermarket power steering

    Does anyone have a parts breakdown of the cylinder on the Anadolu PS add on kits for Ford 4000s. Tisco shows the kit but they don't show a seal kit. Gary
  7. T

    3-Point Hitch  3525 DI Hydraulic system information

    Does any body out there have a 3525 DI. This is the first time I have looked at one. My friend I work with on the side is going to service it for someone. I think the hyd oil is separate from the rear axle. Am I right and where is the rear axle dipstick or check plug? I found the Hyd. stick on...
  8. T

    Turbocharged 3930

    Anybody have the part number of a head gasket for a 98 3930? The online New Holland parts listing shows 1 and it is for a 3930 3/1/90 and later. That gasket clearly does not fit the turbo 3930 after 1/98. Gary
  9. T

    Rotary Cutter  Old Woods bush hog

    Can anybody ID this bush hog? I need a model Number to look up parts. Gary P.S. it's a 6'
  10. T

    New member

    Found this site looking for info. I have a lot of experience on Ford tractors. I have worked at a dealership for 25 of my 40 years working. Might be able to help. Gary

Footer Links 1

Top