pto input shaft splines are shot where it splines into pressure plate. split tractor, removed throwout bearing and 3 bolt cover but shaft will not move, attached gear puller, slide hammer, still no movement. ideas please, thanks in advance
Just overhauled a MF to-35, can't get it to start, has a very erratic spark. Has a pertronix distributor that I don't Know much about. The magnetic ring on distributor has play in it, is this normal or my problem. Thanks
anyone on here Know about these tractors? Need to find #1 top dead center, no indicator on crank pulley, or inspection cover on flywheel. Thanks in advance
Rebuilding front final drive on t 5060,trying to find torque for nut that holds hub to steering knuckle. Book that I have says 289 foot pounds, sounds way to tight to me. Thanks in advance
After setting for 3 or 4 days right brake gets air in system, left side works as it should. Had several opinions on cause but no solutions to stop problem. Thanks in advance.
replacing generator with delco 3 wire setup. after fabricating mounts I ran jumper wire from #2 spade to post on back of gen.then from post to top terminal on starter solenoid. #1 spade terminal was wired to idiot light on dash. started tractor and alternator ins charging 14.5 volts but idiot...