Hello, I have a Woods LS84 loader that works perfectly in all positions except lowering.
The lever will not move forward (to lower loader) Bucket curls up and down fine. Pull lever down to raise loader..works fine.
Also I have noticed the last 2-3 times I used loader that sometimes it feels...
Hello,
I have a Ford 2000 diesel and would like to know it's year model.
Info. I found is Tractor number C262679. Model B1012C. Engine 9M17B.
Trans. 9L10B
Any info. would be greatly appreciated.
Thanks,
Russ
Hello, I have a Kubota B7500HST. left side arm (looking from back) on 3 point lift will not lift. Hydraulics goes up and down correctly only left arm stays down.
Everything is attached. Nothing slipped off. Any ideas what it might be. Where do I start looking?
Thanks.
Hello, I inherited a Ford 2000 diesel. Year model is between 1970-1972.
Need to change hydraulic fluid. What type should I replace old fluid with.
Thanks
Hello, I have a Woods LS84 FEL on a Kubota B7500 for approx. 10 years. Always worked great.
Recently it started having a grinding noise when I curl the bucket down. All other movements are fine.
Fluid level is not low.
Does anyone have any ideas what this might be.
Thanks in advance.
JRF
I recently purchased a new FEL with a 60" bucket. I want to build a toothbar for it. What distance between the teeth would be the best? It seems that at some point, the teeth would become less effective. It seems that most toothbars are in the 8"-10" range. Would 6" between the teeth be o.k...
Just finished a full servicing of my B7500HST. When draining the fluid from the front axle, I found that the drain plug is very close to the tire rim.
Very difficult to get a pan under it. I drained the fluid by holding a funnel under the plug at an angle into my drain pan trying not to get alot...
Anyone have an idea for an air tool holder. I have air tools in bottom drawers of my roll arounds. Tired of having to go through a pile of tools to get to the correct one. Thinking of some type of holder to mount to the end of a workbench or to the wall. Maybe even a holder for a roll around...
Purchased a Caroni finish mower today. No manual with it. The dipstick for the gearbox has 2 small
indentions at the bottom of it. Is this the correct level to keep the gearbox oil? Next question, what
weight of oil and name brand would you recommend? Thanks in advance. JRF
48\" or 60\" RFM for B7500HST
Would a B7500HST handle a 60" rear finish mower? Is it enough H.P.? With the weight of the mower,
would you need to add front weights to the tractor? Thanks in advance, JRF
What is your opinion on these 3 rear finish mowers. In my area I have a choice between First Choice,
King Kutter and Caroni. Which one of these takes the first place prize? I'm interested in well made,
maintenance (easy access to grease fittings and belt changing). Is parts easier to get for...
I'm close to purchasing a new tractor. Current use would be for 100% finish mowing with a FEL & other
attachments coming in a few years. I had decided on the B7800HST w/ turf tires (worried about tearing
up the grass) after comparing the spec's between the B7500HST & the B7800HST. Just...
Need as much information as possible on a IH 255 compact tractor. Local auction has 1 and I may be interested in it. What H.P.? Engine? Power steering? 2 or 4 wd? Advantages and Disadvantages?
Any info. would be greatly appreciated. Thanks in advance. JRF