Search results

Hi, friends! I'm looking for advice again. I have an L39 TLB, and I've been really impressed with this tractor. Over 100 hours use in the past six months, and that's just weekends. 250 hours in two years. But the backhoe is too difficult to remove and replace. One pin is apparently...

Attached (I hope) are a couple of pictures of my L39 at work on a "fixer-upper" house I bought. The L39 has been enormously useful; I've put nearly 100 hours on it since August. Mostly moving junk, but I had to find the old septic system, which took a lot of digging, and I had to replace it...

Thanks to TBN, and especially Muleskinner, I fixed the stiff position control on my L39 3-pt. hitch today. I posted a gripe about a month ago because my 3-pt. hitch control was so stiff that I had to whack it with my hand in order to budge it. Muleskinner PM'd me almost immediately, but I...

The 3-pt. control lever on my L39 is very stiff. Didn't notice until I removed the backhoe and installed the 3-pt. hitch arms. The lever drags against one side of its slot, but I can cope with that by pulling the lever to the opposite side. I squirted a little oil on the point where the...

I drained the front axle of my L39 a week or so ago and replaced the lube with Amsoil ATH, which is the synthetic equivalent of Kubota UDT. The 50 hour old lubricant appeared to have lots of small particles in it; I could see swirl patterns in the draining fluid. Looked like tiny flakes of...

Hi, I have a question regarding efficient loader operation. On most loaders, including that on my L39, the lower left option (joystick pulled back and left) is blanked out on the decal. The first paragraph in the Kubota manual on Operating the Loader explains this... "however the blank...