Search results

There are many reasons for a person to not check into this site. But when an older person is doing a project apparently alone in an out of the way place that could be dangerous for a young person... Should another older person who knows nothing of the facts raise alarm half way around the...

I am getting less able to pick it all up and move it outside into the 'shop'. I want to build a stand with 4 10" HF wheels that will easily roll over the yard. Somewhere I believe I saw a stand made from square tubing that had an extension that doubled the width of the saw table on the left...

I am sure this has been done before but I have been unable to find just how to do it. click on above to see enlarged. (points to hook the 3 point shown in red) The dirt under my tree no longer allows me to smoothly move my engine hoist around and the fold down legs always find something...

I want to use a piece of 1/4 x 2 x 2 angle iron for an axle. I cut 2 - 2 inch pieces for the ends. Will bore a hole and attach wheels with a bolt. What is the best way to align the ends for welding?

This will be category 0 3 point lightweight forks, can the angle iron be turned this way or would a L shape be better? Forks ~34 inches long Frame 20 inches wide.

I'm not in mid-life crises way too late for that, but there are many things that I've been meaning to do that if I don't get to it they aren't going to get done. I'm going to try and forget about the things that I used to be able to do and can't any more and do as much as I can of what I can...

Want to start out with a Miller Multimatic 200 where can I get the best on line price?

I bought this 1983 John Deere 318 without a motor a year or so ago. I am just getting around to getting it running. Have a motor installed and put on a mower deck. Pulled back on the outside lever and nothing happened. Sprayed the levers and valve with WD-40 and tapped the levers with a...