Search results

Ugh... Does anyone have any experience dealing with this 12v power supply located by the left of the toplink on a GC series? It is reliable? Can it power LEDs? Here's the situation. I tested this circuit with a set of worklights and a nilight wiring harness and it worked fine. Went ahead...

Picked up this Cyclone Rake for $250 on Craigslist. Motor is a 6.5hp Tecumseh Enduro, the kind that used to be on gokarts when I was a kid and it runs like a champ. I ordered new bag, mower boot, and longer hose from Cyclone Rake--- they were excellent to deal with. Used a 2x4 and drawbar to...

Just had this carport installed see picture. This spot used to be a single parking spot framed with railroad ties and filled with hardpack. We had fill brought in and added to the existing pad that was there before so the total level area is about 4x the original size. If you look at the...

Naturally I've sucked up a few items harder than snow in the snowblower this season. Anyone have luck with the Massey Ferguson Red Rustoleum? How well does it match? How's it holding up? Did you prime first? Search Results for Massey red at The Home Depot

For the GC series machines with DL95 loader and no backhoe, how much rear ballast is recomended? I was thinking of filling a 55gal plastic barrel with 500lb or so of cement. Just not sure how much weight is ideal. Uses would be snow moving and occasional dirt piles/etc. The manual has no...

Both the manual and sticker next to the loader joystick indicate there is a fast dump mode for the loader bucket on a new GC1705. I have no trouble with float mode but cannot seem to get the bucket to tip any faster than a slow roll. I thought this might be more like a release and gravity...

Greeting! Finding lots of potential high lift blades out there to put on a the 2360/2350 60" deck. The 20mm center hole is a little challenging to match but I have a friend who can bore that to spec for me. The thing I keep running into and not sure about is that all these blades I am finding...