Search results

I have a Kubota G1800 spewing oil from the front of the engine (16 HP Kubota D662 diesel engine). Hard to see where the leak is from as pulleys and flywheel is in the way. I have pulled the PTO pully and flywheel to be able to see. In the center of the picture is the front of the crankshaft...

This is really info in case others have the same problem. So LS XR 4046 with about 100 hours, ECM fuse kept blowing within a few minutes of starting. It was the ECM fuse in the fuse box near the steering wheel that kept blowing. Not the two ECM fuses up near the battery. Took a lot of hours to...

KubotA G1800 with about 900 hours. So I have, what appears to be a small oil leak, where the inlet manifold attaches to the cylinder head. Oozing out between where the inlet manifold attaches to the cylinder head. If could be a bad inlet manifold gasket, but I can't imagine oil being in that...

I'm getting ready to do my 50 hour service. Oil & Filter. Hydraulic filter. Pre-fuel filter, grease, clean radiator, etc. My question is about some of the items on the list, specifically: Check front axle oil level. Torque exhaust manifold bolts. Torque of wheel bolts and nuts. Clutch...

Folks, it took more time to figure this out than to do the install. Getting comfortable that I was tapping into the hydraulics correctly took the most time. Attached is a write up with some pictures that may help others. Rich TITLE: Installing 3rd function remote on LS XR4046 I installed a...

Installing the W.R.Long 3rd function remote. Anyone alreadyi found a convenient source of power for the joy stick? 10 amps desired. Thanks, Rich

I'm installing a 3rd function on a LS 4046. I have to remove the power beyond value, and then attach this to the grapple valve kit. Here is a picture of the fitting to be removed. It looks like it has a nut on both the top and the bottom of the off coming hydraulic hose. How do I remove the...

I am not finding anything with the search engine. What size chain and which type steel should I purchase for a 4046 (46 HP) tractor. Nothing planned, just occasionally lifting, maybe pulling a log or something out of the ditch, lifting something out of the truck. etc. And what length is most...

Happily took delivery of a XR4046 with loader yesterday. Plan on getting the 3rd function remote, grapple, bush hog, box blade for use on my 20 acres here and for deer plots off location (trailer) where we hunt. Looking forward to getting the property cleaned up around here. :thumbsup:

The bearings came apart in the front PTO of my G1800, and I have it apart to replace them all. They were in pieces so I couldn't tell the direction of the oil seal on the bearing. Looking at this pic, bearing (part #30) has ball bearings on one side, and an rubber oil (?) seal on the other...

Help! I am doing the 800 hr service and ready to adjust the valves. The kubota manual does not show the location of the timing window and it doesn't seem to be back in the area of the flywheel. Could it be covered up with the front end loader frame? Anyone know where to look? Thanks, Rich

I recently bought a house and with the house came a L3710 (750 hours) and G1800 (350 hours) to mow the 7 acres of grass. The glow plug light on the dash of the L3710 was not coming on at all, even with the temperation down below 45 degrees. The tractor would start every time after 5 to 7...