Search results

Results 1 to 7 of 7
  1. M

    Leaking diesel from injector pump

    Hello everybody, I found a slow diesel leak from the underside of my JD 5205 injector pump. There is a large size "plug" on the very bottom and is not easy to reach without taking the pump off. Is anybody aware of what this is and why it's leaking? It only leaks a few drips per hour. Picture...
  2. M

    JD X749 starter solenoid without power

    Hey everybody, My JD X749 w/ Yanmar engine is giving me fits. The starter has been finicky for about a year being reluctant to turn over. It seemed if I finessed the key as I was tuning the key it would finally engage. Assuming it was the switch I changed it out without success, and continued...
  3. M

    JD X749 Dying after 30-45 minutes

    Hi all, My last post was almost 2 years ago trying to fix this same problem. First the problem, then what I have tried. This X749 has a 3 cylinder Yanmar with less than 300 hours. It runs and cuts flawlessly and looks like a new motor/mower. It always starts right up regardless of the...
  4. M

    JD X749 Diesel keeps dying out while cutting.

    Hi guys, Kinda new here so bare with me... I have a JD X749 - 4 wheel steer/ 4 wheel drive diesel powered mower that is the best thing since sliced bread! I have had it for over a year and put near 50 hours on it with zero problems. Now I do... While mowing today it suddenly died from full RPM...
  5. M

    Snow Attachments  Snow plow from JD318 mounted to JDX749?

    Hi everybody, I have a JD X749 that I bought last year...Yes I LOVE it completely! But now I'm looking to mount a front plow for snow removal. I was lucky enough to have my neighbor give me a full hydraulic front plow off his old JD 318 today. Knowing it probably would not just bolt up I took it...
  6. M

    Front-End Loader  JD 521 Loader control problems

    Hello everyone, I have a JD 5300 tractor w/ a 521 loader that I bought a few years ago. Upon learning to use the loader I found that the joystick worked as follows: Pull back to raise the boom, push forward to lower the boom, move the stick one click right to tilt bucket up and push further to...
  7. M

    No Kohler spark...EVERYTHING replaced - HELP!

    Hi everybody...I'm new here with a problem that is driving me over the edge. I have a Scag 48" zero turn that is not running. It has always been finicky but now has died with no spark. The engine is an older Kohler magnum 18hp twin cylinder with coil-magneto / flywheel ignition. First I checked...
Top