Search results

Winter is almost here so it is time to get moving on this project. The blade is 8' x 24" x 1/4 rolled at a 24" radius. The ribs are 1/4 plate cut to match the radius on the plasma table at work and 1/4 x 2" flat bar for the cross pieces. The cutting edge is 3/8 x 3" mild steel that is...

I am about to weld some ears for mounting a hydraulic cylinder on my back blade. The welder at work recommender to preheat them before welding (1" thick onto 1/2" backing plate). I did not think to ask him how hot to get them before welding. Thanks, Cam

Friend has just got a 334 excavator, pulled a few blackberry bushes and the hydraulics just stopped. Fluid was a little low so he topped it up. engine shows no fault codes. Any ideas? no blown fuses, interlock down causes light to light on control panel. Cam

Hello all: I have been working on a new back blade for our new tractor for the last few weeks as time permits. I now have most of the steel cut and drilled as needed. I have 2 pieces to take to work to get broke and several small pieces to still acquire. I still have to source the blade itself...

We are looking fora box blade and the question is how wide? our tractor is a Mahindra 3616, 36. hp and 63"wide with R4 tires. Logic would suggest a box blade wider than the tractor. Will I have the power and traction to pull a 72" box blade? The use will be driveway maintenance and some...

Hi all. Have been reading the forum for the last month prior to buying a new tractor. In the end we chose a Mahindra 3616 with a quick change bucket FEL and Agriease 60" rotary brush-cutter for the overall best value. So far we are very happy with the tractor, the brush-cutter may be too light...